KNACRO TPA3116D2 50W+50W Digital Power Amplifier Board Class D 100W DC 9-25V Dual Channel Audio Stereo AMP
KNACRO TPA3116D2 50W+50W Digital Power Amplifier Board Class D 100W DC 9-25V Dual Channel Audio Stereo AMP by KNACRO at Worst Album Covers. MPN: TPA3116D. Hurry! Limited time offer. Offer valid only while supplies last. Board size: 79 * 50 * 18 (L * W * H) mm (not including the potentiometer protruding part 15mm). Operating voltage range: DC 9-25V (current 3A or
Operating voltage range: DC 9-25V (current 3A or more. If you want more power recommended 19-24V / 4A above)
Audio input sensitivity: 600mv.
Speaker impedance: two-channel speaker: 4-8 ohms.
Maximum output power: 50W (left channel) + 50W (right channel) Dual channel
About power selection:
Board is the use of DC power supply, there are positive and negative reverse protection, positive and negative reverse power off.
The power supply does not allow incorrect connection to the speaker output connector, which can cause the amplifier chip to be damaged.
The maximum operating voltage of 25V (Note: Do not use more than 25V).
If you use a common AC adapter power supply, you must add rectifier filter before you can connect to use. (Note: no-load voltage after rectification is not greater than 25V).
Power supply with 12V / 3A or more, left and right speakers with 4 ohms / 15-30W;
Power supply with 19V / 3-4A above, left and right speakers with 4 ohms / 30-50W [These are just a basic parameter, for reference only].
Such as the power requirements are particularly high, the proposed power supply with 20-24V / 4-5A or more, speakers with 4 / 40-80W.
Speaker output wiring:
Speaker output "+" or "-" are independent, not a total of output, can not be connected to each other. And can not be connected with the power "+" or "-", the error will not sound or cause the amplifier chip is damaged.
Speaker output wiring:
The speaker outputs "+" or "-" are independent and can not be connected to each other.
And can not be connected with the power "+" or "-", the wrong connection will sound is not normal or cause the amplifier chip is damaged.
1*DC9-25V TPA3116D2 Digital Amplifier Board Dual-channel Output 50W +50W
Features & Highlights
- Adopt Tpa3116 high-performance amplifier chip as the core, DC single power supply, wide operating Voltage range(9-25v, maximum Voltage is No more than 25V)
- Maximum output power: 50W (left channel) + 50W (Right channel), dual- channel output, efficiency up to 90 percent
- Support pbtl 100W mono output and reserve mute interface (mute), when needed, can connect to the pre-mute interface devices
- Power anti-shock protection design, No pop sonic Boom when turn on/off
- Increase the heat sink to meet with high-voltage power supply, cooling at high power output state needs
|Item Weight:||0.15 pounds|
|Package Weight:||0.15 pounds|
|Package Size:||2.8 x 0.79 x 0.79 inches|